Risers are the primary building components.  All standard configurations have male & female threads except "Blanks" with only male threads.  Risers lift, offset and support other fixturing components or the measured part.  Risers are available in various hex sizes and lengths.













Towers are rectangular components with threaded holes in various orientations.  These stack, lift and support using Group 06 Connectors to secure the assembly.












03-Wall Modules

Walls lift and orient with holes generally parallel to the Group 04 Base Platforms.  Like all components there's no absolute methodology to use and construction.












04-Base Platforms

Platforms are the primary base, easily connected to form larger assemblies or used on top of a stack or in alternate orientations as the task requires.  Base Platforms are available in square or rectangular sizes and Platform Extenders are available in multiple sizes to connect and secure base assemblies.  Platform assemblies are connected to hold a measured part where necessary or to completely cover a CMM table.













Clamps are steel with a variety of styles available.  The primary style is normally used with a compression spring providing the clamping force but these can also be used with a tightened bolt for the force.













Most connectors are standard out-of-the-box varieties.  The S75 System uses SAE 3/8-16 threads, 5/16 Dowels and a few #10-32 threads.












07-Location Pads

Locators are the final component that touches the measured part.  Omni Structures' Locators are hardened steel in various heights and profiles.













The Omni Structures' V-Blocks are split into two pieces allowing wide spacing for larger measured parts.  As necessary, Location Pads are used for the contact surface and Spacers can be used to adjust to the required size.












09-Bridge Modules

The Bridge is used to span open spaces.













Accessories include hand tools, tool boxes and instruction documents.